Barrel Vice Jaws for .22LR Rifles and Pistols

Barrel Vice Jaws

• Made from 6061 T6 Aluminium Billet. Non-anodized aluminium is used because you will get a better grip on the barrel and not mar the finish.
• These are machined for just about any diameter barrel. They drop into your vice (5 inch length of the jaws minimum) for clamping are very easy to use and grip the barrel so you can install muzzle brakes clean the bore and chamber or perform other work that you don't have a third arm and vise hand for.
• These are not "V" blocks they are "U" blocks. They are machined for a 3/4" / 19mm diameter barrel. A smaller barrel will be gripped on "flats" of the larger radius. A larger barrel will be gripped by the edges of the radii. Just clamp down with your vise and the barrel won't spin.
• Forget those welded screw together clamps; use these instead. You can clamp the action on the flats and the barrel in the groove. No wood blocks or split bushings spacer or sleeves here. Get the full clamping power from a vise not two screws.